Silicone Coated PU Timing Belt 90HTD8M-3056

Category

Silicone-coated PU timing belt 90HTD8M-3056

For the silicone-coated PU timing belt 90HTD8M-3056, include the full belt designation when requesting a replacement. Send the belt width, finished length or tooth count, pulley drawing and covering requirements so we can discuss the construction for your machine.

Item Product details
Product type PU timing belt
Designation 90HTD8M-3056
Outer covering Silicone
Tooth profile and pitch Match to your pulley drawing or belt sample
Width and finished length Specify in your inquiry

Share a belt sample or drawing, including any covering, guide or joint requirements.

Gray coiled timing belt with a toothed inner surface
Coiled timing belt with the tooth side, outer face and edge visible.

Construction & detail

Specify the complete 90HTD8M-3056 assembly

Keep the full belt designation with your enquiry, then describe the silicone contact layer and finished assembly. The base-belt code alone does not describe every covering or installation detail.

The product view shows the belt from several angles within the coil. For a machine replacement, include a readable marking and a close-up of the original edge so the base construction and added covering can be discussed together.

Original designation

Copy the complete marking, including any suffixes or supplier part number. Include the equipment model and the drawing revision used for the replacement.

Covering dimensions

Show the covering thickness and width, the overall finished thickness and any uncovered margins. Include the surface finish or hardness requirement where specified.

Running arrangement

Identify drive pulleys, back rollers and any guide grooves. State speed, load and whether the drive starts, stops or reverses during each machine cycle.

Dimensions for a repeat order

For an existing installation, include the original order drawing if available. If several belts run as a matched set, list the quantity per set and the machine’s matching tolerances. Keep the specified length reference separate from a measurement taken around the worn covering.

Specification Information to provide
Belt dimensions Width, finished length or tooth count, and pulley profile
Silicone covering Thickness, hardness if specified, and the required contact-surface finish
Guide arrangement Guide position and cross-section, plus the matching pulley-groove drawing where a guide is required
Cord and joint Required tensile-cord material and joint or endless construction shown on your drawing
Operating conditions Item being handled, speed, load, working temperature and cleaning method

Questions about this belt

Is the designation enough for a repeat order?

It is a useful starting point. Add the covering specification, finished width, length reference, quantity and any guide or joint requirements so the complete assembly is described.

Should I measure over the silicone surface?

Label where and how each measurement was taken. An outside measurement over a covering should not be silently substituted for the length reference specified on the belt drawing.

What if the replacement needs a different covering?

Provide the intended contact material, surface finish and operating conditions, plus the available machine clearance. The covering and base belt need to be considered together.

Tooth-profile reference

Timing belt profile illustration

Use the illustration to discuss tooth shape with your pulley drawing or belt sample. The finished belt profile and dimensions are selected for your machine.

Timing belt tooth-profile illustration
Click the illustration for a larger view.
Scroll to Top

Get a Quote

Tell us the belt type, size and application, and we will review your requirements.

Include your phone number

Get the Catalog

Enter your name and email to download our 2026 product catalog directly after submitting the form.

We use your details to process your catalog request. See our Privacy Policy.