Conveyor belt for dumpling machines
This machine-specific conveyor belt is shown with shaped openings and smaller holes along its edges. For a replacement, provide the machine model and a drawing of the belt and opening layout.
| Item | Details |
|---|---|
| Product | Dumpling machine conveyor belt |
| Form shown | Belt with shaped openings and edge holes |
| Supply | Custom dimensions and layout |
| Brand | LK |
Send the machine reference, belt drawing and required quantity.
Belt dimensions and opening layout
| Item | Details |
|---|---|
| Machine identification | Machine manufacturer, model and existing belt or part reference |
| Finished belt size | Length, width, thickness and dimensional tolerances |
| Shaped openings | Opening shape, length, width, corner radii and centre-to-centre spacing |
| Edge holes | Hole diameter, pitch, offset from each edge and relationship to the main openings |
| Joint and belt route | Joint position, pulley diameters, installation access and tensioning travel |
| Product contact and cleaning | Contact with dough or filling, temperature, cleaning method and required food-contact documentation |
| Quantity and packing | Order quantity and preferred PE-film or carton packaging |
Matching the machine layout
The opening pattern should match the machine layout, including spacing and alignment across the belt. Include photographs of the belt installed in the machine and a drawing showing the relationship between the edge holes and larger openings.
When copying an existing belt, identify the measured dimensions and any worn or stretched areas. State the joint position and the available tensioning travel so the finished belt dimensions can be discussed against the installation.
Material and food-contact requirements
Include the existing material reference or a sample and describe the cleaning conditions. If the belt contacts food, specify the destination market and the documentation required for the selected material and finished assembly.
Request a dumpling machine belt
Send the machine model, drawing or sample details and quantity. Include close-up photographs of the openings, edge holes and joint, along with any installation or conveying issue you need to address.
